INNOVATION DEFINES THE FUTURE...
PRODUCTS GUIDE
Two Piston Pneumatic Actuator
Auto drilling machining center, many manufacturing procedures can be finished via once clamping.
Round off the inner section of cylinder is to avoid piston O-ring hurt when assembling.
Anodize Hardening
Cylinder with over 25μm thickness anodize hardening
coating, dynamic processing for homogeneous coating,
over HV400 hardness, enhance the wear resistance performance vastly.
100-150μm thickness epoxy-polyester coating, double coatings were suitable for severe, corrosive working conditions.
*Based on different conditions, please refer to our
<ALL TORQUE D-T COATING SPECS> should you have any special requirements for protective coatings,we shall
try our best to meet you.
Drive Pinion
quality forged alloy steel was treated with quenched-tempered heat, via 13 manufacturing procedures, 0.03mm thickness coating of chemical nickel-phosphate plating with homogeneous,pyknotic and shining appearance, is very high hardness, thickness uniformity and wear resisting.
Full tooth design
and precision casting echnicals,
higher strength, tight bite,
4 CNC machining steps, then polish and anodized hardening to be a complete part.
Application Fields
ALL TORQUE actuators were widely used in petrochemical industry,marine engineering,power plant,mining&metallurgy,water treatment,polysilicon plant,
locomotive manufacturing fields.
ABOUT US
CUSTOMIZATION
HELP CENTER
NEWS
CONTACT US
CopyRight 2016 © ZHEJIANG DINGFENG FLUID AUTOCONTROL EQUIPMENT CO.,LTD. All Rights Reserved. 23rd floor, Oushang Bldg, Louqiao Sub-district, Ouhai District, Wenzhou, Zhejiang, China